Figure 1
1.Peel protective film off the duct cover and the hood (if any).
2.Place rubber seal on hood venting area as shown in Figure 3. Use eight (4x20 screws (provided) to attach plastic damper and rubber seal to hood venting are to Figure 4.
Figure 3 | Figure 4 |
3.If necessary to remove the two rubber stands at the back of the hood, unscrew discard.
Hood Installation
CAUTIIN: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
4.Using references in Table 1 and measurements on page 13, mark the leveling poi
5.Secure
Figure 5
5