Zanussi ZGF 782 manual Important safety requirements, Location

Page 10

Important safety requirements

This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).

Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room with a volume of less than 20 m3. If it is installed in a room of volume less than 5 m3 an air vent of effective area of 110 cm2 is required. If it is installed in a room of volume between 5 m3 and 10 m3 an air vent of effective area of 50 cm2 is required, while if the volume exceeds 11 m3 no air is required.

However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m3 and 11 m3.

If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements.

INSTALLATION GUIDANCE INSTRUCTIONS

CLEARANCES REQUIRED

WHEN FITTING THE GAS HOB

WITHOUT A COOKER HOOD ABOVE

700 mm

 

 

 

 

400 mm

 

 

 

 

 

mm

 

 

50

 

55

 

 

mm

 

400 mm

 

 

 

 

 

 

 

100

mm

 

 

 

 

 

 

 

 

 

 

50

mm

 

 

 

 

FO 2027

Location

The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that the edges of the hob that are to be near either a side or rear wall have a minimum distance of 55 mm. between the edge of the hob and the wall.

The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 420 mm. If it is fitted below 420 mm. a space of 50

mm.must be allowed from the edges of the hob. The minimum distance combustible material can be fitted directly above the hob is 700 mm.

A minimum distance of 100 mm. must be left between the side edges of the hob and any adjacent cabinets or walls.

Important

If a 60 cm cooker hood is be installed above the hob, ensure a minimum distance of 780 mm is left between the hanging furniture units beside the cooker hood (see diagram below).

INSTALLATION GUIDANCE INSTRUCTIONS

 

 

CLEARANCES REQUIRED

 

 

WHEN FITTING THE GAS HOB

 

 

WITH A COOKER HOOD ABOVE

 

 

 

600 mm

 

 

 

 

780 mm min.

 

 

650 mm

 

 

 

 

400 mm

 

 

 

 

mm

 

 

 

50

55

 

 

 

mm

 

400 mm

 

 

 

100

mm

 

 

 

 

 

 

 

 

 

50

mm

 

 

 

 

 

FO 2231

 

 

 

11

Image 10
Contents GAS HOB Model ZGF Service Important Safety InformationChild Safety During UseContents Description of the Hob Installation When the HOB is First InstalledHob Top HOB Burners Using the Wok StandOperation Burner Minimum MaximumPan Supports and Wok Stand Maintenance and CleaningHobTop BurnersSomething Not Working? Service and Spare PartsSymptom Solution Customer CareEuropean Guarantee Zanussi Guarantee ConditionsExclusions This guarantee does not cover Peace of Mind for 24 MonthsOverall Dimensions Instructions for the InstallerEngineer technical data CUT OUT DimensionsImportant safety requirements LocationGas Connection InstallationDimensions are given in mm Cut Out SizeBuilding Fitting the Hob into the worktopElectrical connections This HOB Must be EarthedWiring Diagram Ignitor Switch Ignitor UnitPreliminary Electrical Systems Check Fault FindingEarth Continuity Check Ignition System / Gas Ignition Pressure Testing ProcedureCommissioning To Adjust the GAS Rate Servicing