Zanussi ZCM 7902 Installation Instructions, For Your Safety, Choice of Electrical Connection

Page 29

INSTALLATION INSTRUCTIONS

FOR YOUR SAFETY

Where applicable Natural Gas and L.P Gas versions of this appliance are available. Check that this model is suitable for the type of supply available. In the interest of safety this appliance must be installed and/or serviced by a competent person, as stated in Gas Safety (Installation and Use) Regulations Current Editions.

WARNINGS:

￿This appliance must be installed by a qualified electrician/competent person (CORGI Registered). Safety may be impaired if installation is not carried out in accordance with these instructions.

￿Do not remove the screws from the earth tab extending from the main oven terminal block (Fig 2).

￿Before connecting the appliance make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This is situated on the lower front frame of the appliance and can be seen upon opening the door. Alternatively the rating plate may also be found on the back or top of some models (where applicable).

￿Do not alter the electrical circuitry of this appliance.

￿Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instruction. If this is the case contact the person who installed the appliance.

Warning: This appliance must be earthed.

Do not earth this appliance to the gas supply piping.

CHOICE OF ELECTRICAL CONNECTION

￿The appliance should be operated using at least 6mm2 twin core and earth PVC insulated muticore cable.

￿By connecting the appliance to a cooker point having a double pole isolating switch providing at least 3mm contact separation in all poles and protected with a fuse or miniature circuit breaker at your mains fuse box.

NOTE: It is good practice to:

￿Fit an Earth Leakage Circuit breaker to your house wiring.

￿Wire your appliance to the latest IEE regulations.

THINGS TO NOTE

￿If this appliance is to be fitted between cabinets the recommended dimensions as shown in Fig. 1 and the instructions on ‘Location of appliance’ must be followed.

￿Enquiries regarding the installation of the cooker point if required should be made to your Regional Electricity Company to ensure compliance with their regulations.

￿The cooker point should be within 2m of the appliance to make it accessible to switch off the appliance in case of an emergency.

NOTE: HOUSE CIRCUIT

Earth leakage / continuity tests must be carried out before the appliance is connected to the mains supply and rechecked after fitting.

29

Image 29
Contents Electric Double Oven Grill with Important Safety Information Contents Preface Introduction Grill and Oven Furniture Control Panel ZCM7902 FeaturesControl Panel To SET the Time of DAY TimerTo USE the Timer Automatic Control Setting the Controls for Automatic USEGAS HOB Hints and Tips Uses of the Dual Grill Dual GrillSelecting the Dual Grill Grill PAN and HandleFood Shelf Grill Time Grilling ChartUses of the TOP Oven TOP OvenSelecting the TOP Oven To FIT the TOP Oven ShelfHints and Tips Uses of the FAN Oven Main OvenSelecting the Main Oven To FIT the Main Oven ShelvesHints and Tips Oven Cooking Chart Roasting Chart Roasting ChartSelecting Defrost Defrost FeatureUses of Defrost Feature When Replacing Hotplate Burner Parts Care and CleaningCleaning the HOB Cleaning the Control Knobs and Handles Cleaning the Outside of the ApplianceCleaning the Grill and Oven Furniture Care of Stayclean SurfacesCleaning Between the Outer and Inner Door Glass Cleaning the Door GlassTo Remove the Outer Glass To Replace the Outer GlassReplacing the Oven Light Bulb To Clean the Inner Glass Door PanelsAppliance does not work at all Something not WORKING?Service and Spare Parts Standard guarantee conditions Guarantee ConditionsLoading info Electric ovens Technical DetailsChoice of Electrical Connection Installation InstructionsFor Your Safety Moving Your Appliance Important Safety RequirementsProvision for Ventilation Location of Appliance Connecting to the Electricity Supply Connecting to GAS Supply Fitting the Stability Bracket Checking the Grill Pressure TestingChecking the Hotplate Checking LID SHUT-OFF DeviceGeneral Note Checking the Main OvenChecking the Second Oven Page Page Page ZANUSSI-ELECTROLUX