Cisco Systems 274, 474 manual Installing the Wide Area Virtualization Engine

C H A P T E R 3

Installing the Wide Area Virtualization Engine

This chapter describes how to install a Wide Area Virtualization Engine (WAVE) appliance on a tabletop, on a wall, or in an equipment rack. This chapter contains the following sections:

•Installing the WAVE Appliance on a Tabletop, page 3-2

•Installing the WAVE Appliance on a Wall, page 3-2

•Installing the WAVE Appliance in an Equipment Rack, page 3-5

•Connecting Cables, page 3-6

•Connecting Power and Booting the System, page 3-6

•Checking the LEDs, page 3-7

•Removing or Replacing a WAVE Appliance, page 3-7

Before you begin the installation, read Chapter 2, “Preparing to Install the Wide Area Virtualization Engine” and the Regulatory Compliance and Safety Information for the Cisco Wide Area Virtualization Engine 274 and 474 document.

Warning Read the installation instructions before connecting the system to the power source. Statement 1004

	Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
OL-17739-01		3-1