Chapter 5 Troubleshooting the System Hardware
Table | POST Diagnostic Front Panel LEDs and Beep Codes (continued) | ||||
|
|
|
|
| |
Activity |
| Beeps | Possible Cause | Recommended Action | |
|
|
|
|
| |
Red Power LED flashes ten | 10 | Bad option card. | 1. | Check installed cards by | |
times, once every second, |
|
|
| removing the card (one at a | |
followed by a |
|
|
| time if multiple cards), and | |
pause. Beeps stop after fifth |
|
|
| then power on the system to | |
iteration but LEDs continue |
|
|
| see if fault goes away. | |
until problem is solved. |
|
| 2. | Once a bad card is | |
|
|
|
| ||
|
|
|
|
| identified, remove and |
|
|
|
|
| replace the bad card. |
|
|
|
| 3. | Contact Cisco TAC. |
|
|
|
| ||
System does not power on | None | System unable to power on. | Press and hold the power button | ||
and LEDs are not flashing. |
|
| for less than 4 seconds. If the | ||
|
|
|
| hard drive LED turns green, the | |
|
|
|
| power button is working | |
|
|
|
| correctly. | |
|
|
|
| If the hard drive LED does not | |
|
|
|
| turn on green then try the | |
|
|
|
| following: | |
|
|
|
| 1. | Check that the unit is |
|
|
|
|
| plugged into a working AC |
|
|
|
|
| outlet. |
|
|
|
| 2. | Check that the power button |
|
|
|
|
| harness is connected to the |
|
|
|
|
| system board. |
|
|
|
| 3. | Check that both power |
|
|
|
|
| supply cables are properly |
|
|
|
|
| connected to the system |
|
|
|
|
| board. |
|
|
|
| 4. | Contact Cisco TAC. |
|
|
|
|
|
|
| Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide |
|
