Chapter 5 Troubleshooting the System Hardware

 

 

 

Power-On Self Test (POST)

 

Table 5-10

Diagnostic Front Panel LEDs and Beep Codes (continued)

 

 

 

 

Control Panel Message

Description

 

 

 

 

917-Front Audio Not Connected

Front audio harness has been detached or unseated

 

 

 

from motherboard.

 

 

 

 

918-Front USB Not Connected

Front USB harness has been detached or unseated

 

 

 

from motherboard.

 

 

 

 

922-This system only supports SDVO/ADD2

The SDVO connector on the system board has the

 

cards in the x16 slot

physical appearance of a PCI Express x16

 

 

 

connector; however, the platform does NOT

 

 

 

support the use of conventional PCI Express cards

 

 

 

or reversed layout ADD2 cards.

 

 

 

 

1151-Serial Port A Address Conflict Detected

Both external and internal serial ports are assigned

 

 

 

to COM1.

 

 

 

 

1152-Serial Port B Address Conflict Detected

Both external and internal serial ports are assigned

 

 

 

to COM2.

 

 

 

 

1155-Serial Port Address Conflict Detected

Both external and internal serial ports are assigned

 

 

 

to the same IRQ.

 

 

 

 

1201-System Audio Address Conflict Detected

Device IRQ address conflicts with another device.

 

 

 

 

1202-MIDI Port Address Conflict Detected

Device IRQ address conflicts with another device.

 

 

 

 

1203-Game Port Address Conflict Detected

Device IRQ address conflicts with another device.

 

 

 

 

1720-SMART Hard Drive Detects Imminent

Hard drive is about to fail. (Some hard drives have

 

Failure

 

a hard drive firmware patch that will fix an

 

 

 

erroneous error message.)

 

 

 

 

1796-SATA Cabling Error

One or more SATA devices are improperly

 

 

 

attached.

 

 

 

 

1797-SATA Drivelock is not supported in RAID

Drivelock is enabled on one or more SATA hard

 

mode.

 

drives, and they cannot be accessed while the

 

 

 

system is configured for RAID mode.

 

 

 

 

1801-Microcode Patch Error

Processor is not supported by ROM BIOS.

 

 

 

 

2216-Powered USB cable not attached

Powered USB cable is not properly attached to the

 

 

 

USB PlusPower expansion card or to the system

 

 

 

board.

 

 

 

 

Invalid Electronic Serial Number

Electronic serial number has become corrupted.

 

 

 

 

Memory Parity Error

Parity RAM failure.

 

 

 

 

 

 

 

 

 

Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide

 

 

 

 

 

 

 

OL-17739-01

 

 

 

5-15

 

 

 

 

 

Page 67
Image 67
Cisco Systems 274, 474 manual Power-On Self Test Post