2-5
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
OL-17739-01
Chapter 2 Preparing to Install the Wide Area Virtualization Engine
Safety Guidelines
• If any of the following conditions occur, unplug the product from the
electrical outlet and replace the part or contact your customer service
representative:
–
The power cable or plug is damaged.
–
An object has fallen into the product.
–
The product has been exposed to water.
–
The product has been dropped or damaged.
–
The product does not operate correctly when you follow the operating
instructions.
• Keep your system components away from radiators and heat sources. Also,
do not block cooling vents.
• Do not spill food or liquids on your system components, and never operate
the product in a wet environment.
• Do not push any objects into the openings of your system components. Doing
so can cause fire or electric shock by shorting out interior components.
• Use the product only with other Cisco-approved equipment.
• Allow the product to cool before removing covers or touching
internal components.
• Use the correct external power source. Operate the product only from the type
of power source indicated on the electrical ratings label. If you are not sure
of the type of power source required, consult your service representative or
local power company.
• Use only approved power cables. If you have not been provided with a power
cable for your WAVE appliance or for any AC-powered option intended for
your system, purchase a power cable that is approved for use in your country.
The power cable must be rated for the product and for the voltage and current
marked on the product’s electrical ratings label. The voltage and current
rating of the cable should be greater than the ratings marked on the product.
• To help prevent electric shock, plug the system components and peripheral
power cables into properly grounded electrical outlets. These cables are
equipped with three-prong plugs to help ensure proper grounding. Do not use
adapter plugs or remove the grounding prong from a cable.