Cisco Systems 274, 474 manual Post Numeric Codes and Text Messages

Chapter 5 Troubleshooting the System Hardware

Power-On Self Test (POST)

Note A single problem might cause several error messages. When this situation occurs, you should correct the cause of the first error message. After you correct the cause of the first error message, the other error messages usually will not occur the next time that you run the test.

POST Numeric Codes and Text Messages

This section covers POST errors that have numeric codes associated with them. The section also includes some text messages that may be encountered during POST.

		Note	The computer will beep once after a POST text message is displayed on the
			screen.
Table 5-10		Diagnostic Front Panel LEDs and Beep Codes
	Control Panel Message			Description
	101-Option ROM Checksum Error			System ROM or expansion board option ROM
				checksum.
	103-System Board Failure			DMA or timers.
	110-Out of Memory Space for Option ROMs			Recently added PCI expansion card contains an
				option ROM too large to download during POST.
	162-System Options Not Set			Configuration incorrect.
				RTC (real-time clock) battery may need to be
				replaced.
	163-Time & Date Not Set			Invalid time or date in configuration memory.
				The RTC (real-time clock) battery may need to be
				replaced.
	163-Time & Date Not Set			CMOS jumper may not be properly installed.
	164-Memory Size Error			Memory amount has changed since the last boot
				(memory added or removed).
	164-Memory Size Error			Memory configuration incorrect.
			Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
	OL-17739-01				5-13