TIC ASP60, ASP100, AS P25, ASP120 manual An Important note on Polarity

A note on Speaker Cable;

TIC recommends the use of our SPC30, 50 or 100’ double insulated high quality speaker cable, however just about any reasonable speaker cable may be used including existing runs that may be in place. For standard 8 installations of 10 – 25ft., just about any 16/18 gauge 2 core cables can usually be used although we would prefer a double insulated or burial spec cable be used. For longer runs of 25 – 100ft. 10/14 gauge cable can be used however resistance down the line will become a contributing factor.

Please visit TIC Corporations website at www.ticcorp.com and review the

Audio Installation Basics articles under Technical Resources for more in depth exterior audio and cable guidelines.

An Important note on Polarity!

Pleasure proper polarity when connecting your new TIC outdoor speakers. This is very important and will result in poor sound reproduction and possibly equipment damage if not connected correctly. This is normally avoided by ensuring + to + and – to – or as sometimes color coded Red to Red and Black to Black from your amplified source to your speakers respectively.

5.Once you have checked the components and tested the system ready for exterior install, recheck your cable runs carefully marking the correct channel for each speaker.

6.Mount your speakers carefully using the supplied mounting brackets for each patio speaker.

7.Connect you new TIC Patio Speakers at the speaker end first ensuring enough “play” in the cable to allow angle adjustment as necessary.

8.Reconnect the speakers to your receiver amplifier being careful to ensure correct “Polarity” matching.

9.*for 70v systems note diagram below;

TIC ASP60 & ASP120 models only