Brother PR-620 operation manual Installing the bobbin case, Installing the Bobbin

Installing the bobbin

1Insert the bobbin into the bobbin case.

Note

●Check that the thread winds off the bobbin clockwise as shown in the illustration. If the bobbin is installed with the thread winding off in the opposite direction, the embroidery will not be sewn correctly.

2Pass the thread through the thread slit and under the tension-adjusting spring.

1

2

1Thread slit

2Tension-adjusting spring

3Pull the thread through the opening in the tension-adjusting spring.

1

1Pull out about 50 mm (2 inches) of thread.

Installing the bobbin case

1Insert the bobbin case into the hook.

Insert the bobbin case while aligning the tab on the bobbin case with the notch in the hook, as shown in the illustration.

1

2

1Tab

2 Notch

• Fully insert the bobbin case until it snaps into place.

2Close the hook cover.

Memo

●This embroidery machine is not equipped with a bobbin-winder. Use pre-wound (L type) bobbins.

●The optional bobbin winder (stand-alone type) and optional metal bobbins can also be used. (Refer to page 5, 188.)

2

1

2

3

4

5

6

7

8

9

10

11

12

13

14

Installing the Bobbin 19