Brother PR-620 operation manual Make sure the notch comes out

7While pulling the cap down with one hand, pull the lever of the snap lock to securely close it.

1

1Lever of the snap lock

Note

●Make sure that there are no wrinkles within the clamping frame. Otherwise miss alignment will occurred.

8While again pulling on the fabric around the cap frame to stretch it, adjust the embroidering position.

9Pull the brim holder up as far as possible. Next, turn the brim holder over the cap brim, and then lower the brim holder. Finally, arrange the brim so that it maintains a slightly rounded shape.

1Brim holder

2Centerline of brim presser

• Make sure the notch comes out.

0As shown in the illustration, use both hands to press in on the sides of the brim to reshape it so that the sides do not fold out.

If the pattern is embroidered with the sides of the brim folded out, the brim will hit the machine and cause the pattern to become misaligned.

aStretch the fabric in the embroidering area so that it is taut.

While pressing in on the sides of the brim, the fabric within the cap frame may be pressed, causing slack in the fabric. Pull the fabric along the left, right and center seams in the direction of the arrows, and stretch the fabric so that the embroidering area is taut.

X This completes the positioning of the cap in	7
the standard cap frame.

Using the Optional Cap Frame 179