Brother PR-620 operation manual Changing the color thread table

6Repeat steps 2 through 5 to specify colors for the other boxes.

•To change the color specified in a box, delete the previous color, and then specify a new one.

■Changing the color thread table

Set “DISPLAY EXPANDED THREAD COLOR” to “ON”, and then select the color thread. Refer to page 146.

Specifying jumpstitch trimming / “DST” jump codes for trimming

You can specify whether or not jumpstitches are cut. In addition, when using Tajima embroidery data (.dst), you can specify whether or not the thread is cut according to the specified number of jump codes.

ON: The machine cuts the upper and bobbin thread before the jumpstitch. When Tajima embroidery data (.dst) is used, the machine converts the “jump” code to a trim code, based on the number specified on the next line.

OFF: The machine does not cut either a jumpstitch or the “jump” code in Tajima embroidery data (.dst). When the machine is purchased, “ON” is selected and the number of jumps is set to “3”.

The “DST” thread trim settings can be specified from the second page of the settings screen.

1Touch (or ) and select the desired setting.

The key appears as when “ON” is

selected, and it appears as when “OFF” is selected.

6

•Each touch of the key turns the setting either on or off.

Note

●This setting is not applied to the trimming of threads between characters in alphabet patterns. (Refer to “Trimming the threads between characters” on page 125.)

Memo

●The number of jump codes cannot be specified for data other than Tajima embroidery data (.dst).

Using the Settings Key 149