Brother PR-620 operation manual Setting up the machine, Foot can be turned

GETTING READY ———————————————————————————————————————————————————

Setting up the machine

When setting up the machine, adjust the legs so that the machine is steady.

1Make sure that all packing tape affixed to the machine is peeled off and that all packing material is removed.

2Set up the machine while making sure that there is sufficient space around it.

		More than
		50 mm
		(2 inches)
		589 mm
		(23-3/16
		inches)
		More than
		350 mm
		(13-3/4 inches)
More than	512 mm	More than
250 mm	(20-5/32 inches)	250 mm
(9-7/8 inches)		(9-7/8 inches)

3Adjust the legs so that the machine is steady. Use the included wrench to loosen the lock nut on the leg that you wish to adjust.

1

2

1Lock nut

2Adjustable foot nut

XThe foot can be turned.

4Use the included wrench to turn the adjustable foot nut on the foot.

Turning the nut in direction 1 lengthens the leg; turning the nut in direction 2 shortens the leg.

2

1 1

1Adjustable foot nut

•Adjust all four legs so that they securely contact the desk or table.

5After adjusting the legs to the desired length, use the included wrench to tighten the nuts.

1

1 Lock nut

6Press down on each corner of the embroidery machine to check that it is stable.

If it is still unstable, perform steps 3 through

5again to adjust the legs.

8