Brother PR-620 operation manual Error messages, Installed embroidery frame is too small

Error messages

If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is performed, the machine stops and informs you of the error with a buzzer and an error message. If an error message appears, correct the problem according to the instructions in the message.

To close the message, touch or perform the correct operation, then touch . If the message appears again, consult your nearest authorized dealer.

The pattern extends out of the 200 mm (H) × 300 mm (W) embroidering area.

Move the pattern into the embroidering area.

The upper thread was cut or the thread came out the thread tension disc or a thread guide. The machine is not threaded correctly.

Check that the thread is under the upper and middle thread guides and correctly thread the upper thread.

(Refer to page 35.)

The installed embroidery frame is too small.

Check which embroidery frames can be used, and then install a larger embroidery frame. (Refer to page 28.)

The bobbin thread was broken or ran out.

Check that there is thread on the bobbin and that approxi- mately 50 mm (2 inches) of thread has been pulled out, and then re-install the bobbin. (Refer to page 19.)

There are too many characters to be arranged on the curve. Reduce the number of charac- ters.

The machine couldn't delete the data.

The media may be damaged.

Patterns on the embroidery card cannot be read.

The embroidery card may be damaged.

Characters have been com- bined until they extend out of the embroidery frame. Decrease the number of charac- ters so that they fit within the embroidery frame.

7

Six manual needle bar settings were being specified.

No more than five needle bars can be specified.

Troubleshooting 207