NETGEAR Comprehensive Guide to the GS752TP Manual for Optimal Network Configuration

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

The initial value is blank. This information is not retained across a power cycle. The maximum number of characters in a name is 160.

3.Optionally, configure the following settings:

•In the Count field, specify the number of pings to send. The valid range is 1–15.

•In the Interval (secs) field, specify the number of seconds between pings sent. The valid range is 1–60.

•In the Size field, specify the size of the ping (ICMP) packet to send. The valid range is 0–65507.

•The Results field displays the result after the switch sends a ping request to the specified address.

4.Click APPLY to send the ping. The switch sends the number of pings specified in the Count field, and the results are displayed in the Results field.

•If a reply to the ping is received, you see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, Rx = x Min/Max/Avg RTT = x/x/x msec.”

•If a reply to the ping is not received, you see “Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec.”

Ping IPv6

Use the Ping IPv6 screen to send a ping request to a specified host name or IPv6 address. This checks whether the switch can communicate with a particular IPv6 station. When you click the APPLY button, the switch sends three pings, and the results are displayed.

To configure the settings and ping a host on the network:

1.Select Maintenance > Troubleshooting > Ping IPv6. The following screen displays:

239