NETGEAR GS752TP, GS728TPP manual  To configure Vlan settings

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches

To configure VLAN settings:

1.Select Routing > VLAN > VLAN Routing Wizard. The following screen displays:

2.In the VLAN ID field specify a VLAN ID.

This VLAN identifier (VID) associated with this VLAN is created if it does not exist. The valid range is 1–4093.

3.In the IP Address field, specify the IP address of the VLAN interface.

4.In the Network Mask field, specify the subnet mask of the VLAN interface.

5.Select the operation mode for ports and LAGs.

The Port and LAG fields each display selectable physical ports and LAGs (if any). Selected interfaces are added to the routing VLAN. Each interface can be configured to operate in one of three modes:

•T(Tagged). Select the interfaces on which all frames transmitted for this VLAN are tagged. The interfaces that are selected are included in the VLAN.

•U(Untagged). Select the interfaces on which all frames transmitted for this VLAN are untagged. The interfaces that are selected are included in the VLAN.

•BLANK(Autodetect). Select the interfaces that might be dynamically registered in this VLAN using GVRP. This selection has the effect of excluding an interface from the selected VLAN.

6.Click APPLY to send the updated configuration to the switch. Configuration changes take place immediately.

128