74
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
2. Next to Global Flow Control (IEEE 802.3x) Mode, enable or disable IEEE 802.3x flow control
on the system. The factory default is Disable.
•Enable. The switch sends pause packets if the port buffers become full.
•Disable. The switch does not send pause packets if the port buffers become full.
3. View the Jumbo Frames Status.
4. In the Jumbo Frames After Reset list, select Enable or Disable.
Jumbo frames support takes effect only after it is enabled, and after the switch is
rebooted. The Jumbo Frames Status field displays the status of this feature.
5. Click APPLY to apply the changes to the system.
Port Configuration
Use the Port Configuration screen to configure the physical interfaces on the switch.
To configure port settings:
1. Select Switching Ports Port Configuration.
The following screen displays:
2. Select the interface for which you want to configure settings.
•To configure settings for a physical port, click PORTS.
•To configure settings for a link aggregation group (LAG), click LAGS.
•To configure settings for both physical ports and LAGs, click All.
3. Select the check box next to the port or LAG to configure.