RoboteQ AX2850 user manual Configuring Controller using Switches, Programming Methods

SECTION 14 Configuring the

Controller using

the Switches

The AX2550 Speed Controller can be programmed to operate in many modes using

asimple set-up procedure. Two buttons and a 7-segment LED display allow the user to examine and change these settings. Alternatively, the controller may be pro- grammed using a PC connected to the AX2550 controller through the RS232 serial communication port.

The new settings are then permanently stored in the controller’s Flash memory so that jumpers are not required, resulting in improved system reliability.

Programming Methods

There are three methods for programming the AX2550’s settings:

•Using the controller’s built-in switches and display. This method is described in details in this chapter.

•Using the PC-based Configuration Utility. See “Using the Roborun Configura- tion Utility” on page 177.

•Sending RS232 commands manually. See “Automatic Switching from RS232 to RC Mode” on page 165.

Programming using built-in Switches and Display

Two switches and an LED display are provided to let you easily configure the con- troller in any of its many operating modes. Unlike the RS232 programming mode, the switches will let you configure the controller without the need for external hard- ware or special connectors. In this mode, the controller may be configured while installed on the robot without the need for special tools or a PC. Figure 96 shows the placement of the switches and display.

AX2550 Motor Controller User’s Manual 171