Cisco Systems A9014CFD manual Configuration Example for Lldp, Verifying Lldp, 28-4

Chapter 28 Configuring Link Layer Discovery Protocol

Configuration Example for LLDP

Verifying LLDP

To verify LLDP on the Cisco ASR 901 router, use the show command as shown in the following example.

Router# show lldp ?

entry	Information for specific neighbor entry
errors	LLDP computational errors and overflows
interface	LLDP interface status and configuration
neighbors	LLDP neighbor entries
traffic	LLDP statistics
	Output modifiers
<cr>

Router# show lldp entry *

Capability codes:

(R)Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device

(W)WLAN Access Point, (P) Repeater, (S) Station, (O) Other

Configuration Example for LLDP

This section provides the following configuration examples:

•Example: Enabling LLDP Globally

•Example: Configuring Hold Time

•Example: Configuring Delay Time

•Example: Configuring Intervals

Example: Enabling LLDP Globally

Router> enable

Router# configure terminal

Router(config)# lldp run

Router(config)# end

Example: Configuring Hold Time

Router> enable

Router# configure terminal

Router(config)# lldp holdtime 100

Router(config)# end

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
28-4	OL-23826-09