Cisco Systems A9014CFD manual Configuring ATM/IMA Pseudowire Redundancy in PVC Mode, 21-22

Chapter 21 Configuring Pseudowire

Configuring Hot Standby Pseudowire Support for ATM/IMA

Example: Pseudowire Redundancy

This example shows pseudowire redundancy configured for a CEM circuit (group). In the example, the xconnect command configures a primary pseudowire for CEM group 0. The backup peer command creates a redundant pseudowire for the group.

int cem 0/1 no ip address cem 0

xconnect 10.10.10.1 1 encap mpls backup peer 10.10.10.2 200 exit

Configuring Hot Standby Pseudowire Support for ATM/IMA

This section describes how to configure ATM/IMA pseudowire redundancy:

•Configuring ATM/IMA Pseudowire Redundancy in PVC Mode

•Configuring ATM/IMA Pseudowire Redundancy in PVP Mode

•Configuring ATM/IMA Pseudowire Redundancy in Port Mode

•Verifying Hot Standby Pseudowire Support for ATM/IMA

Note Both the primary and backup pseudowires must be provisioned for the Hot Standby Pseudowire Support feature to work.

Configuring ATM/IMA Pseudowire Redundancy in PVC Mode

Complete the following steps to configure pseudowire redundancy in permanent virtual circuit (PVC) mode.

SUMMARY STEPS

1.enable

2.configure terminal

3.interface interface-name

4.pvc vpi/vci l2transport

5.encapsulation { aal0 aal5 }

6.xconnect peer-ip-addressvc-idencapsulation mpls

7.backup peer peer-router-ip-addr vcid

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
21-22	OL-23826-09