Cisco Systems A9014CFD manual Configuration Examples for Remote LFA-FRR, 39-35

Chapter 39 Remote Loop-Free Alternate - Fast Reroute

Configuration Examples for Remote LFA-FRR

transit packet totals: receive 64465447, send 64465519

transit byte totals: receive 15987430856, send 15987448712

transit packet drops: receive 0, seq error 0, send 0

Verifying Remote LFA-FRR Configuration on SAToP

To verify the remote LFA-FRR configuration on SAToP, use the show commands described in the following example.

Router# show mpls l2 vc 111 detail

Local interface: CE0/0 up, line protocol up, SATOP Basic 1 up

Destination address: 2.2.2.2, VC ID: 111, VC status: up

Output interface: Vlan300, imposed label stack {29 32}

Preferred path: not configured

Default path: active

Next hop: point2point

Create time: 17:54:25, last status change time: 17:54:25

Last label FSM state change time: 17:54:25

Signaling protocol: LDP, peer 2.2.2.2:0						up
Targeted Hello: 170.0.0.201(LDP				Id) -> 2.2.2.2, LDP is UP
Graceful restart: not configured and not							enabled
Non stop routing: not configured and not							enabled
Status	TLV support (local/remote)				: enabled/supported
LDP route watch					: enabled
Label/status state machine					: established, LruRru
Last	local dataplane		status	rcvd: No			fault
Last	BFD dataplane		status	rcvd: Not sent
Last	BFD peer monitor		status	rcvd: No			fault
Last	local AC	circuit status		rcvd: No			fault
Last	local AC	circuit status		sent: No			fault
Last	local PW i/f circ status			rcvd: No			fault
Last	local LDP TLV		status	sent: No			fault
Last	remote LDP TLV		status	rcvd: No			fault
Last	remote LDP ADJ		status	rcvd: No			fault
MPLS VC labels: local 20, remote 32
Group ID: local 0, remote 0
MTU: local 0, remote 0
Remote	interface description:

Sequencing: receive disabled, send disabled

Control Word: On (configured: autosense)

Configuration Examples for Remote LFA-FRR

This section provides sample configuration examples for Remote LFA-FRR feature on the

Cisco ASR 901 router.

•Example: Configuring Remote LFA-FRR for IS-IS, page 39-36

•Example: Configuring Remote LFA-FRR for OSPF, page 39-36

•Example: Configuring Remote LFA-FRR Globally, page 39-36

•Example: Configuring Remote LFA-FRR on a GigabitEthernet Interface, page 39-37

•Example: Configuring Remote LFA-FRR on an SVI Interface, page 39-37

•Example: Configuring EoMPLS Pseudowire Redundancy over FRR, page 39-37

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		39-35