Cisco Systems A9014CFD manual Configuring Class-map for Matching Mpls EXP Bits, 24-76

Chapter 24 Configuring QoS

Extending QoS for MLPPP

	Command	Purpose
Step 13
	set mpls experimental topmost	Sets the MPLS EXP field value in the topmost label on an interface.
	mpls-exp-value	• mpls-exp-value—Specifies the value used to set MPLS experimental
	Example:	bits defined by the policy map.
	Router(config-pmap-c)# set mpls
	experimental topmost 6
Step 14
	class class-name	Specifies the name of the class whose policy you want to create.
	Example:
	Router(config-pmap-c)# class
	class-default
Step 15
	bandwidth percent percentage	Configures the bandwidth allocated for a class belonging to a policy map.
	Example:
	Router(config-pmap-c)# bandwidth
	percent 20
Step 16
	end	Exits QoS policy-map class configuration mode.
	Example:
	Router(config-pmap-c)# exit

Attaching the Policy-map to Match on CS5 and EXP4 to MLPPP Interface

See “Attaching the Policy-map to MLPPP Interface” section on page 24-78for configuration steps.

Note DSCP CS6 and EXP 6 are default values. If you configure the CPU generated traffic to these values using CLI, you cannot see them in the output of the show running-configurationcommand.

Configuration Examples for Extending QoS for MPLS over MLPPP

•Configuring Class-map for Matching MPLS EXP Bits, page 24-76

•Configuring Class-map for Matching IP DSCP Value, page 24-77

•Configuring Class-map for Matching MPLS EXP Bits or IP DSCP Value, page 24-77

•Configuring a Policy-map, page 24-77

•Attaching the Policy-map to MLPPP Interface, page 24-78

Configuring Class-map for Matching MPLS EXP Bits

The following example shows a configuration of class-map for matching MPLS EXP bits.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
24-76	OL-23826-09