Cisco Systems A9014CFD manual Ethernet oam max-rate oampdus min-rate seconds, 10-37

Chapter 10 Configuring Ethernet OAM

	Command	Purpose
Step 4
	ethernet oam [max-rate oampdus min-rate seconds	Configures the OAM parameters:
	[ms] mode {active passive} timeout seconds	• max-rate—(Optional) Configures the maximum
	[ms] ]
		number of OAM PDUs sent per second.
		• oampdus—The range is from 1 to 10.
		• min-rate—(Optional) Configures the minimum
		transmission rate when one OAM PDU is sent per
		second.
		• seconds—The range is as follows:
		– 1 to 10 seconds
		– 100 to 900 milliseconds (multiples of 100)
		• ms—Specifies the minimum transmission rate value in
		milliseconds.
		• mode active—(Optional) Sets OAM client mode to
		active.
		• mode passive—(Optional) Sets OAM client mode to
		passive.
		Note When Ethernet OAM mode is enabled on two
		interfaces passing traffic, at least one must be in the
		active mode.
		• timeout—(Optional) Sets a time for OAM client
		timeout.
		• seconds—The range is as follows:
		– 2 to 30 seconds
		– 500 to 1900 milliseconds (multiples of 100)
		• ms—Specifies the timeout value in milliseconds.
Step 5
	end	Returns to privileged EXEC mode.
Step 6
	show ethernet oam status [interface interface-id]	Verifies the configuration.
Step 7
	copy running-config startup-config	(Optional) Saves your entries in the configuration file.

Use the no ethernet oam interface configuration command to disable Ethernet OAM on the interface.

Configuration Example

The following example shows how to configure an Ethernet OAM session with sub-second OAM timers on an interface:

Router> enable

Router# configure terminal

Router(config)# interface gigabitethernet 0/1

Router(config-if)# ethernet oam

Router(config-if)#ethernet oam min-rate 100 ms

Router(config-if)#ethernet oam timeout 500 ms

Router(config-if)# end

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		10-37