Cisco Systems A9014CFD Configuring PIM SSM Options, Enable Configure terminal Ipv6 pim, 42-11

Chapter 42 IPv6 Multicast

Configuring IPv6 Multicast

Configuring PIM SSM Options

To configure PIM Source-Specific Multicast options, complete the following steps.

SUMMARY STEPS

1.enable

2.configure terminal

3.ipv6 pim

4.interface type number

5.ipv6 pim hello-interval interval-in-seconds

6.ipv6 pim join-prune-interval interval-in-seconds

DETAILED STEPS

	Command		Purpose
Step 1	enable		Enables privileged EXEC mode.
			• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal		Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3	ipv6 pim		Configures PIM, if it is disabled. PIM runs on every interface after
			configuring IPv6 multicast routing.
	Example:
	Router(config)# ipv6 pim
Step 4	interface type number		Specifies an interface type and number, and enters interface
			configuration mode.
	Example:
	Router(config)# interface
	gigabitethernet 0/1
Step 5	ipv6 pim hello-interval		Configures periodic hello interval for this interface. Default is 30
	interval-in-seconds		seconds. Periodic hellos are sent out at intervals randomized by a
			small amount instead of on exact periodic interval.
	Example:
	Router(config-if)# ipv6 pim
	hello-interval 45
Step 6	ipv6 pim join-prune-interval		Configures periodic Join-Prune announcement interval for this
	interval-in-seconds		interface. Default is 60 seconds.
	Example:
	Router(config-if)# ipv6 pim
	join-prune-interval 75
		Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09				42-11