Cisco Systems A9014CFD manual Configuring Unspecified Bit Rate Plus, Ubr+ pcr-rate mcr-rate, 36-13

Chapter 36 Configuring Inverse Muliplexing over ATM

How to Configure ATM Class of Service

	Command	Purpose
Step 4	pvc VPI/VCI l2transport	Specifies the VPI and VCI of the PVC and configures the PVC in
		layer 2 transport mode.
	Example:	• l2transport is an optional field.
	Router(config-if)# pvc 100/12
	l2transport
Step 5	ubr rate	Configures the UBR QoS class for an ATM permanent virtual circuit
		(PVC) and specifies the bandwidth. By default a value is set to UBR
	Example:	ATM class of service with the rate equal to the bandwidth of the
		IMA interface, which in turn is a product of the number of active
	Router(config-if-atm-vc)# ubr 16000
		IMA links and the bandwidth of each link.
		• rate—Peak cell rate in Kbps.

Configuring Unspecified Bit Rate Plus

Complete the following steps to configure Unspecified Bit Rate Plus (UBR+) QoS class for an ATM permanent virtual circuit () and to specify the bandwidth on the Cisco ASR 901 series router.

SUMMARY STEPS

1.enable

2.configure terminal

3.interface ATMslot/imagroup-number

4.pvc VPI/VCI l2transport

5.ubr+ pcr-rate mcr-rate

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters the global configuration mode.
	Example:
	Router# configure terminal
Step 3	interface ATMslot/IMAgroup-number	Configures an ATM interface and enters the interface configuration
		mode.
	Example:
	Router(config)# interface ATM1/IMA0

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		36-13