Cisco Systems A9014CFD manual Vrrp group-numberpriority level, 27-7

Chapter 27 Hot Standby Router Protocol and Virtual Router Redundancy Protocol

How to Configure VRRP

7.vrrp [group-number]priority level

8.vrrp [group-number]authentication text string

9.vrrp [group-number]track object-number [decrement priority-decrement]

10.end

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	interface type number	Configures an interface type and enters interface
		configuration mode.
	Example:
	Router(config)# interface Vlan10
Step 4
	ip address ip-address mask	Specifies a primary or secondary IP address for an interface.
	Example:
	Router(config-if)# ip address 10.10.10.25
	255.255.255.0
Step 5
	vrrp [group-number]timers advertise [msec]	Configures the interval at which packets are sent to refresh
		the MAC cache when VRRP is running
	Example:
	Router(config-if)# vrrp 2 timers advertise 2
Step 6
	vrrp [group-number]preempt [delay minimum	Configures preemption delay.
	seconds]
	Example:
	Router(config-if)# vrrp 2 preempt delay minimum
	10
Step 7
	vrrp [group-number]priority priority	Configures VRRP priority.
	Example:
	Router(config-if)# vrrp 2 priority 200
Step 8
	vrrp [group-number]authentication text string	Configures an authentication string for VRRP text
		authentication.
	Example:
	Router(config-if)# vrrp 2 authentication text
	cisco7

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		27-7