Cisco Systems A9014CFD manual Alias alias-short-ma-name icc icc-code meg-id, 10-9

Chapter 10 Configuring Ethernet OAM

	Command	Purpose
Step 5
	continuity-check	Enable sending and receiving of continuity check
		messages.
	Example:
	Router(config-ecfm-srv)# continuity-check
Step 6
	continuity-check interval value	(Optional) Set the interval at which continuity check
		messages are sent. The available values are 100 ms,
	Example:	1 second, 10 seconds, 1 minute and 10 minutes. The default
		is 10 seconds.
	Router(config-ecfm-srv)# continuity-check
	interval 1s	Note Because faster CCM rates are more CPU-intensive,
		we do not recommend configuring a large number
		of MEPs running at 100 ms intervals.
Step 7
	continuity-check loss-threshold threshold-value	(Optional) Set the number of continuity check messages to
		be missed before declaring that an MEP is down. The range
	Example:	is 2 to 255; the default is 3.
	Router(config-ecfm-srv)# continuity-check
	loss-threshold 4
Step 8
	alias{alias-short-ma-name icc icc-code meg-id	Define a customer alias maintenance association (MA)
	number ma-number vlan-idvlan-id vpn-idvpn-id}	name or number or VPN ID to be associated with the
		domain, a VLAN ID or port MEP, and enter
	Example:	ethernet-cfm-service configuration mode.
		• alias-short-ma-name—a string of no more than 100
	Router(config-ecfm-srv)# alias MA6
		characters that identifies the MAID.
		• icc icc-codemeg-id—specify the ITU Carrier Code
		(ICC) (maximum: 6 characters) and Unique
		Maintenance Entity Group (MEG) ID Code (UMC).
		The maximum characters allowed is 12.
		• number ma-number—a value from 0 to 65535.
		• vlan-idvlan-id—VLAN range is from 1 to 4094. You
		cannot use the same VLAN ID for more than one
		domain at the same level.
		• vpn-idvpn-id—enter a VPN ID as the ma-name.
Step 9
	exit	Return to ethernet-CFM configuration mode.
Step 10
	exit	Return to global configuration mode.
Step 11
	interface interface-id	Specify an interface to configure, and enter interface
		configuration mode.
	Example:
	Router(config)# interface gigabitethernet 0/4
Step 12
	service instance number ethernet name	Specify the service instance number and the name of the
		EVC.
	Example:
	Router(config-if)# service instance 30 ethernet
	EVC30

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		10-9