Cisco Systems A9014CFD manual As a match criterion, Cs-value-The Class SelectorCS value, 24-75

Chapter 24 Configuring QoS

Extending QoS for MLPPP

	Command	Purpose
Step 4
	match ip dscp cs-value	Identify one or more differentiated service code point (DSCP) CS value
		as a match criterion.
	Example:	• cs-value—The Class Selector(CS) value.
	Router(config-cmap)# match ip dscp
	cs5
Step 5
	class-map match-any class-map-name	Creates a class map to be used for matching packets to a specified class.
		• class-map-name—Name of the class for the class map.
	Example:
	Router(config-cmap)# class-map
	match-any exp4
Step 6
	match mpls experimental topmost	Matches the experimental (EXP) value in the topmost label header.
	number	• number—Multiprotocol Label Switching (MPLS) EXP field in the
	Example:	topmost label header. Valid values are 0 to 7.
	Router(config-cmap)# match mpls
	experimental topmost 4
Step 7
	policy-mappolicy-map-name	Configures a policy map that can be attached to one or more interfaces and
		enters QoS policy-map configuration mode.
	Example:	• policy-map-name—Name of the policy map.
	Router(config-cmap)# policy-map
	dscp_exp
Step 8
	class class-name	Specifies the name of the class whose policy you want to create.
		• class-name—Name of the class to be configured or whose policy is
	Example:	to be modified. The class name is used for both the class map and to
	Router(config-pmap)# class dscpcs5	configure a policy for the class in the policy map.
Step 9
	bandwidth percent percentage	Configures the bandwidth allocated for a class belonging to a policy map.
		• percentage—Specifies the percentage of guaranteed bandwidth based
	Example:	on an absolute percent of available bandwidth to be set aside for the
	Router(config-pmap-c)# bandwidth	priority class or on a relative percent of available bandwidth.
	percent 20
Step 10
	set ip dscp cs-value	Marks a packet by setting the differentiated services code point (DSCP)
		value in the type of service (ToS) byte.
	Example:
	Router(config-pmap-c)# set ip dscp
	cs6
Step 11
	class class-name	Specifies the name of the class whose policy you want to create.
	Example:
	Router(config-pmap-c)# class exp4
Step 12
	bandwidth percent percentage	Configures the bandwidth allocated for a class belonging to a policy map.
		• percentage—Specifies the percentage of guaranteed bandwidth based
	Example:	on an absolute percent of available bandwidth to be set aside for the
	Router(config-pmap-c)# bandwidth	priority class or on a relative percent of available bandwidth.
	percent 20

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		24-75