Cisco Systems A9014CFD manual Configuring Slave Ordinary Clock, 22-21

Chapter 22 Configuring Clocking

Configuring PTP for the Cisco ASR 901 Router

	Command	Purpose
Step 7	transport ipv4 unicast interface	Sets port transport parameters.
	interface-type interface-number	• interface-type—The type of the interface.
	Example:	• interface-number—The number of the interface.
	Router(config-ptp-port)# transport
	ipv4 unicast interface loopback 0
Step 8	clock-destination clock-ip-address	Specifies the IP address of a clock destination when the
		router is in PTP master mode.
	Example:
	Router(config-ptp-port)#
	clock-destination 8.8.8.1
Step 9	sync interval interval	(Optional) Specifies the interval used to send PTP
		synchronization messages. The intervals are set using log
	Example:	base 2 values. The Cisco ASR 901 router supports the
		following values:
	Router(config-ptp-port)# sync
	interval -5	• -5—1 packet every 1/32 seconds, or 32 packets per
		second.
		• -6—1 packet every 1/64 seconds, or 64 packets per
		second.
		The default is -6.
Step 10	announce interval interval	(Optional) Specifies the interval for PTP announce
		messages. The intervals are set using log base 2 values, as
	Example:	follows:
	Router(config-ptp-port)# announce	• 4—1 packet every 16 seconds
	interval 2	• 3—1 packet every 8 seconds
		• 2—1 packet every 4 seconds
		• 1—1 packet every 2 seconds
		• 0—1 packet every second
		The default is 1.
Step 11	end	Exits clock port configuration mode and enters privileged
		EXEC mode.
	Example:
	Router(config-ptp-port)# end

Configuring Slave Ordinary Clock

Complete the following steps to configure a slave ordinary clock:

SUMMARY STEPS

1.enable

2.configure terminal

3.ptp clock ordinary domain domain

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		22-21