Cisco Systems A9014CFD manual Configures the media type, Auto-select-Specifies dynamic selection

Chapter 7 Configuring Gigabit Ethernet Interfaces

Configuring a Combo Port

–If both media are installed in the combo port, and the router is reloaded or the port is disabled and then re-enabled through the shutdown and the no shutdown interface configuration commands, the router gives preference to the SFP module interface.

SUMMARY STEPS

1.enable

2.configure terminal

3.interface gigabitethernet slot/port

4.media-type {auto-select rj45 sfp}

5.end

DETAILED STEPS

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	interface gigabitethernet slot/port	Selects a Gigabit Ethernet interface and enters
		interface configuration mode.
	Example:	• slot/port—Specifies the slot and port number.
	Router(config)# interface gigabitethernet 0/1
Step 4
	media-type {auto-select rj45 sfp}	Configures the media type.
		• auto-select—Specifies dynamic selection of the
	Example:	physical connection.
	Router(config-if)# media-type rj45	• rj45—Specifies an RJ-45 physical connection.
		• sfp—Specifies an SFP physical connection for
		fiber media.
Step 5
	end	Exits interface configuration mode and enters
		privileged EXEC mode.
	Example:
	Router(config-if)# end

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

OL-23826-09 7-7