Chapter 24 Configuring QoS

Verifying MPLS over MLPPP Configuration

Verifying MPLS over MLPPP Configuration

To verify the configuration of MPLS over MLPPP, use the following commands as shown in the examples below:

To verify the details of a class-map created for matching MPLS EXP bits, use the following command as shown in the example below:

Router# show run class-map mpls_exp1

Building configuration...

Current configuration : 76 bytes

!

class-map match-any mpls_exp1 match mpls experimental topmost 1

!

end

To verify the details of a class-map created for matching IP DSCP values, use the following command as shown in the example below:

Router# show run class-map dscpaf21

Building configuration...

Current configuration : 60 bytes

!

class-map match-any dscpaf21 match ip dscp af21

!

end

To verify the details of a policy-map, use the following command as shown in the example below:

Router# show run policy-map policy_match_dscpaf11

Building configuration...

Current configuration : 100 bytes

!

policy-map policy_match_dscpaf11 class dscpaf11

set ip dscp af22 priority percent 10

!

end

To verify the details of a policy-map attached to MLPPP interface, use the following command as shown in the example below:

Router# show policy-map interface multilink3

Multilink3

Service-policy output: match_dscp_exp

Class-map: dscpcs4 (match-any) 0 packets, 0 bytes

 

 

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

 

 

 

 

 

 

OL-23826-09

 

 

24-79

 

 

 

 

 

Page 515
Image 515
Cisco Systems A9014CFD manual Verifying Mpls over Mlppp Configuration, 24-79