Cisco Systems A9014CFD manual Port Based EoMPLS, Show mpls l2t vc id, 15-5

Chapter 15 Configuring EoMPLS

Port Based EoMPLS

	Command	Purpose
Step 10	Router(config-if-srv)# rewrite	Specifies the encapsulation modification to occur on packets at ingress as
	ingress tag pop 1 symmetric	follows:
		• pop 1—Pop (remove) the outermost tag.
		• symmetric—Configure the packet to undergo the reverse of the
		ingress action at egress. If a tag is popped at ingress, it is pushed
		(added) at egress.
		Note Although the symmetric keyword appears to be optional, you
		must enter it for rewrite to function correctly.
Step 11
	Router(config-if-srv)# xconnect	Binds the VLAN attachment circuit to an Any Transport over MPLS
	11.205.1.1 141 encapsulation mpls	(AToM) pseudowire for EoMPLS.
Step 12
	Router(cfg-if-ether-vc-xconn)#	Specifies a backup peer for redundancy.
	backup peer 13.205.3.3 1141
Step 13
	end	Returns to privileged EXEC mode.
Step 14
	• show mpls l2t vc id	Use these commands to display pseudowire information.

•show mpls l2t vc detail

•show mpls infrastructure lfd pseudowire internal

Port Based EoMPLS

Port mode allows a frame coming into an interface to be packed into an MPLS packet and transported over the MPLS backbone to an egress interface. The entire ethernet frame without the preamble or frame check sequence (FCS) is transported as a single packet. To configure port mode, use the xconnect command in the main interface mode and specify the destination address and the VC ID. The syntax and semantics of the xconnect command are the same as for all other transport types. Each interface is associated with one unique pseudowire VC label.

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router> configure terminal

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		15-5