Chapter 25 Configuring MLPPP

Prerequisites

Prerequisites

Cisco IOS Release 15.2(2)SNI or a later release that supports the Multiprotocol Label Switching (MPLS) over MLPPP feature must be installed previously on the Cisco ASR 901 Series Aggregation Services Router.

Cisco Express Forwarding (CEF) or distributed Cisco Express Forwarding (dCEF) should be enabled.

MPLS should enabled on PE and P routers.

Before enabling MPLS over MLPPP link, configure the following commands:

mpls label protocol ldp

mpls ip (configure this command over MLPPP link where IP address has been enabled)

Restrictions

TE-FRR/LFA FRR feature is not supported on the MLPPP interface.

Virtual Routing and Forwarding (VRF) configuration is not supported on the MLPPP interface.

You need to shut down and bring up the MLPP interface for the following conditions:

On the fly fragmentation enable or disable

On the fly changes to the fragment size

Link fragmentation interleave

Enabling multiclass

If the CPU command is modified when IS-IS is configured, you should remove and re-apply the service-policy in MLPPP.

MLPPP Optimization Features

The Cisco ASR 901 supports several features that improve the performance of Multilink Point-to-Point Protocol (MLPPP) connections and related applications such as IP over MLPPP. Some important features are given below:

Distributed Multilink Point-to-Point Protocol Offload

Multiclass MLPPP

MPLS over MLPPP

Distributed Multilink Point-to-Point Protocol Offload

Distributed Multilink Point-to-Point Protocol (dMLPPP) allows you to combine T1 or E1 connections into a bundle that has the combined bandwidth of all of the connections in the bundle, providing improved capacity and CPU utilization over MLPPP. The dMLPPP offload feature improves the performance for traffic in dMLPPP applications such as IP over MLPPP by shifting processing of this traffic from the main CPU to the network processor.

 

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

25-2

OL-23826-09

Page 526
Image 526
Cisco Systems A9014CFD Prerequisites, Mlppp Optimization Features, Distributed Multilink Point-to-Point Protocol Offload