Cisco Systems A9014CFD manual Example Configuring CFM, Example Configuring EEP Applet, 31-11

Chapter 31 Microwave ACM Signaling and EEM Integration

Configuration Examples for Microwave ACM Signaling and EEM Integration

To display microwave bandwidth statistics of an interface, use the following show command.

Router# show ethernet event microwave statistic [interface]

Microwave Bandwidth Statistics for GigabitEthernet0/0/2

Total VSM Receive Count : 145

Total VSM Drop Count : 0

Number of transitions into Degraded state : 2

Configuration Examples for Microwave ACM Signaling and EEM Integration

This section provides sample configuration examples for Microwave ACM Signaling and EEM Integration feature on the Cisco ASR 901 router.

•Example: Configuring CFM, page 31-11

•Example: Configuring EEP Applet, page 31-11

•Example: Configuring Event Handler, page 31-15

Example: Configuring CFM

The following is a sample configuration of CFM.

!

ethernet cfm domain outer level 3

service microwave1 evc V60 vlan 60 direction down continuity-check

!

ethernet evc V60

!

interface GigabitEthernet0/11

!

service instance 60 ethernet V60 encapsulation dot1q 60

rewrite ingress tag pop 1 symmetric bridge-domain 60

!

Example: Configuring EEP Applet

The following is a sample EEM script to configure metric on a microwave link and adjust a QoS policy according to the ethernet event parameters sent through OAM.

Note You should have one SVI/BD per physical link. Also, one EEM script is required per physical link. In all, there should be two EEM scripts and two SVI/BDs:

! ACM script

no event manager applet ACM62 event manager applet ACM62

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		31-11