Cisco Systems A9014CFD manual Configuring Referenced On-Demand Operation on a Sender MEP, 11-20

Chapter 11 ITU-T Y.1731 Performance Monitoring

How to Configure IP SLAs Y.1731 On-Demand and Concurrent Operations

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	ip sla on-demand ethernet slm domain domain-name	Creates and runs an on-demand operation in direct
	{evc evc-id vlan vlan-id} {mpid target-mp-id	mode.
	mac-address target-address}cos cos {source {mpid
	source-mp-id mac-addresssource-address}}	Repeat this step for each on-demand operation to be
	{continuous [interval milliseconds] burst [interval	run.
	milliseconds] [number number-of-frames] [frequency
	seconds]} [size bytes] aggregation seconds {duration
	seconds max number-of-packets}
	Example:
	Router# ip sla on-demand ethernet SLM domain xxx
	vlan 12 mpid 34 cos 4 source mpid 23 continuous
	aggregation 10 duration 60

Configuring Referenced On-Demand Operation on a Sender MEP

Prerequisites

Single-ended and concurrent Ethernet delay, or delay variation, and frame loss operations to be referenced must be configured.

SUMMARY STEPS

1.enable

2.ip sla on-demand ethernet slm operation number {duration seconds max number-of-packets}

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	ip sla on-demand ethernet slm operation number	Creates and runs a pseudo operation of the operation
	{duration seconds max number-of-packets}	being referenced, in the background.
	Example:	Repeat this step for each on-demand operation to be
		run.
	Router# ip sla on-demand ethernet slm 11

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
11-20	OL-23826-09