Cisco Systems A9014CFD Configuring ETH-LCK, Show ethernet cfm smep interface interface-id, 10-28

Chapter 10 Configuring Ethernet OAM

	Command	Purpose
Step 18
	end	Return to privileged EXEC mode.
Step 19
	show ethernet cfm smep [interface interface-id]	Verify the configuration.
Step 20
	show ethernet cfm error	Display received ETH-AIS frames and other errors.
Step 21
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

Use the no form of this commands to return to the default configuration or to remove a configuration. To disable the generation of ETH-AIS frames, enter the disable config-ais-link-cfm mode command.

This is an example of the output from the show ethernet cfm smep command when Ethernet AIS has been enabled:

Router# show ethernet cfm smep SMEP Settings:

--------------

Interface: GigabitEthernet1/0/3

LCK-Status: Enabled

LCK Period: 60000 (ms)

Level to transmit LCK: Default

AIS-Status: Enabled

AIS Period: 60000 (ms)

Level to transmit AIS: Default

Defect Condition: AIS

Configuring ETH-LCK

Complete the following steps to configure ethernet locked signal on a switch:

	Command	Purpose
Step 1
	configure terminal	Enter global configuration mode.
Step 2
	ethernet cfm lck link-status global	Execute SMEP LCK commands by entering
		config-lck-link-cfm mode.
Step 3
	level level-id	Configure the maintenance level for sending ETH-LCK
		frames transmitted by the SMEP. The range is 0 to 7.
	or	or
	disable	Disable the generation of ETH-LCK frames.
Step 4
	period value	Configure the SMEP ETH-LCK frame transmission period
		interval. Allowable values are 1 second or 60 seconds.
Step 5
	exit	Return to global configuration mode.
Step 6
	ethernet cfm domain domain-namelevel level-id	Define a CFM domain, set the domain level, and enter
		ethernet-cfm configuration mode for the domain. The
		maintenance level number range is 0 to 7.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
10-28	OL-23826-09