Cisco Systems A9014CFD manual Udp port local localudpport remote remoteudpport, 21-16

Chapter 21 Configuring Pseudowire

Configuring Pseudowire

14.cem group-number

15.xconnect peer-router-id vcid {pseudowire-class name}

16.udp port local local_udp_port remote remote_udp_port

17.end

DETAILED STEPS

	Command		Purpose
Step 1	enable		Enables privileged EXEC mode.
			• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal		Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3	pseudowire-class		Creates a new pseudowire class.
	pseudowire-class-name
	Example:
	Router(config)# pseudowire-class
	udpClass
Step 4	encapsulation udp		Specifies the UDP transport protocol.
	Example:
	Router(config-pw-class)#
	encapsulation udp
Step 5	ip local interface loopback		Configures the IP address of the provider edge (PE) router interface as the
	interface-number		source IP address for sending tunneled packets.
	Example:
	Router(config-pw-class)# ip local
	interface loopback1
Step 6	ip tos value value-number		Specifies the type of service (ToS) level for IP traffic in the pseudowire.
	Example:
	Router(config-pw-class)# ip tos
	value 100
Step 7	ip ttl number		Specifies a value for the time-to-live (TTL) byte in the IP headers of Layer
			2 tunneled packets.
	Example:
	Router(config-pw-class)# ip ttl 100
Step 8	exit		Exits pseudowire-class configuration mode.
	Example:
	Router(config-pw-class)# exit
		Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
21-16			OL-23826-09