Cisco Systems A9014CFD manual Configuring IP SLA CFM Operation, 10-16

Chapter 10 Configuring Ethernet OAM

Note Use the no form of each command to remove a configuration or to return to the default settings.

Configuring IP SLA CFM Operation

You can manually configure an individual IP SLA ethernet ping, or jitter echo operation, or you can configure IP SLA ethernet operation with endpoint discovery. You can also configure multiple operation scheduling. For accurate one-way delay statistics, the clocks on the endpoint switches must be synchronized. You can configure the endpoint switches with Network Time Protocol (NTP) so that the switches are synchronized to the same clock source.

For more information about configuring IP SLA ethernet operations, see the IP SLAs Configuration Guide, Cisco IOS Release 15.0S. For detailed information about commands for IP SLAs, see the Cisco IOS IP SLAs Command Reference.

Note The Cisco ASR 901 does not necessarily support all of the commands listed in the Cisco IOS IP SLA documentation.

This section includes these procedures:

•Manually Configuring an IP SLA CFM Probe or Jitter Operation, page 10-16

•Configuring an IP SLA Operation with Endpoint Discovery, page 10-18

Manually Configuring an IP SLA CFM Probe or Jitter Operation

To manually configure an IP SLA ethernet echo (ping) or jitter operation, complete the following steps:

	Command		Purpose
Step 1
	configure terminal		Enter global configuration mode.
Step 2
	ip sla operation-number		Create an IP SLA operation, and enter IP SLA
			configuration mode.
Step 3
	ethernet echo mpid identifier domain domain-name		Configure the IP SLA operation as an echo (ping) or jitter
	vlan vlan-id		operation, and enter IP SLA ethernet echo configuration
	or		mode.
	ethernet jitter mpid identifier domain domain-name		• Enter echo for a ping operation or jitter for a jitter
			operation.
	vlan vlan-id [interval interpacket-interval]
	[num-framesnumber-of frames transmitted]		• For mpid identifier, enter a maintenance endpoint
			identifier. The identifier must be unique for each
			VLAN (service instance). The range is 1 to 8191.
			• For domain domain-name, enter the CFM domain
			name.
			• For vlan vlan-id, the VLAN range is from 1 to 4095.
			• (Optional—for jitter only) Enter the interval between
			sending of jitter packets.
			• (Optional—for jitter only) Enter the num-framesand
			the number of frames to be sent.
		Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
10-16			OL-23826-09