Cisco Systems A9014CFD manual Removing Sources or Destination from a Span Session, 43-5

Chapter 43 Configuring Switched Port Analyzer

Configuring SPAN

4.source {interface interface_type slot/port} {vlan vlan_ID} {service instance id interface_type slot/port} [, - rx tx both]

5.destination {interface interface_type slot/port}

6.no shutdown

DETAILED STEPS

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	monitor session {session_number} type local	Specifies the SPAN session number.
	Example:
	Router(config)# monitor session 1 type local
Step 4
	source {interface interface_type slot/port} {vlan	Specifies the source interfaces, VLANs, or service
	vlan_ID} {service instance id interface_type	instances, and the traffic direction to be monitored.
	slot/port} [, - rx tx both]
	Example:
	Router(config-mon-local)# source interface
	gigabitethernet 0/8
Step 5
	{destination {interface interface_type slot/port}	Specifies the destination interface.
	Example:
	Router(config-mon-local)# destination interface
	gigabitethernet 0/11
Step 6
	no shutdown	Enables the SPAN session using the no shutdown
		command.
	Example:
	Router(config-mon-local)# no shutdown

Removing Sources or Destination from a SPAN Session

To remove sources or destination from a SPAN session, use the following commands beginning in executive mode:

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		43-5