Cisco Systems A9014CFD manual Configuring Single-Ended Synthetic Loss Measurement, 11-9

Chapter 11 ITU-T Y.1731 Performance Monitoring

How to Configure ITU-T Y.1731 Performance Monitoring

	Command	Purpose
Step 11
	max-delaymilliseconds	(Optional) Sets the amount of time an MEP waits for
		a frame.
	Example:	• milliseconds—Specifies the maximum delay in
	Router(config-sla-y1731-delay)# max-delay 5000	milliseconds (ms). The range is from 1 to 65535.
		The default is 5000.
Step 12
	owner owner-id	(Optional) Configures the owner of an IP SLAs
		operation.
	Example:	• owner-id—Specifies the name of the SNMP
	Router(config-sla-y1731-delay)# owner admin	owner. The value is from 0 to 255 ASCII
		characters.
Step 13
	end	Exits IP SLA Y.1731 delay configuration mode and
		enters privileged EXEC mode.
	Example:
	Router(config-sla-y1731-delay)# end

What to Do Next

After configuring two-way delay measurement, see the Scheduling IP SLAs Operations, page 11-14to schedule the operation.

Configuring Single-Ended Synthetic Loss Measurement

Note To display information about remote (target) MEPs on destination devices, use the show ethernet cfm maintenance-points remote command.

Complete the following steps to configure a single-ended SLM.

Prerequisites

Class of Service (CoS)-level monitoring must be enabled on MEPs associated to the Ethernet frame loss operation using the monitor loss counter command on the devices at both ends of the operation.

Note Cisco IOS Y.1731 implementation allows monitoring of frame loss for frames on an EVC regardless of the CoS value (any CoS or Aggregate CoS cases). See the "Configuration Examples for IP SLAs Metro-Ethernet 3.0 (ITU-T Y.1731) Operations" section for configuration information.

SUMMARY STEPS

1.enable

2.configure terminal

3.asr901-platf-multi-nni-cfm

4.ip sla operation-number

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		11-9