Cisco Systems A9014CFD Configuring the Twamp Reflector, Configuration Examples for Twamp, 23-8

Chapter 23 Cisco IOS IP SLA

Two-Way Active Measurement Protocol

Configuring the TWAMP Reflector

The TWAMP server and reflector functionality are both configured on the same device.

Complete the following steps to configure the TWAMP reflector:

SUMMARY STEPS

1.enable

2.configure terminal

3.ip sla responder twamp

4.timeout seconds

5.end

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 1
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 2
	ip sla server twamp	Configures the switch as a TWAMP responder, and enter TWAMP
		configuration mode.
	Example:
	Router(config)# ip sla server twamp
Step 3
	timer inactivity seconds	(Optional) Sets the maximum time, in seconds. The session can be inactive
		before the session ends. The range is between 1 to 604800 seconds. The
	Example:	default is 900 seconds.
	Router(config-twamp-srvr)# timer
	inactivity 300
Step 4
	end	Return to privileged EXEC mode.
	Example:
	Router(config-twamp-srvr)# end

Configuration Examples for TWAMP

This section provides the following configuration examples:

•Example: Configuring the Router as an IP SLA TWAMP server

•Example: Configuring the Router as an IP SLA TWAMP Reflector

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
23-8	OL-23826-09