Cisco Systems A9014CFD manual ATM AAL5 SDU VCC Transport, 36-9

Chapter 36 Configuring Inverse Muliplexing over ATM

Configuring ATM IMA over MPLS

4.atm pvp VPI l2transport

5.xconnect ip-addressport-numberencapsulation mpls

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters the global configuration mode.
	Example:
	Router# configure terminal
Step 3	interface ATMslot/IMAgroup-number	Specifies the slot location and port of IMA interface group and
		configures the ATM interface.
	Example:	• slot—Specifies the slot location of the ATM IMA port adapter.
	Router(config)# interface ATM0/IMA0	• group-number—Specifies the group number of the IMA group.
Step 4	atm pvp VPI l2transport	Specifies the VPI of the PVP and configures the PVP in L2transport
		mode.
	Example:
	Router(config-if)# atm pvp 10
	l2transport
Step 5	xconnect ip-address port-number	Binds an attachment circuit to the ATM IMA interface to create a
	encapsulation mpls one-to-one	pseudowire.
	Example:
	Router(config-if-atm-l2trans-pvp)#
	xconnect 30.30.30.2 305 encapsulation
	mpls

ATM AAL5 SDU VCC Transport

An ATM AAL5 SDU VCC transport pseudowire maps a single ATM to another ATM. You must use AAL5 encapsulation for this transport type. Complete the following steps to configure an ATM AAL5 SDU VCC transport pseudowire:

SUMMARY STEPS

1.enable

2.configure terminal

3.interface ATMslot/IMAgroup-number

4.VPI/VCI l2transport

5.encapsulation encapsulation-type

6.xconnect ip-addressport-numberencapsulation mpls

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		36-9