Cisco Systems A9014CFD manual Flexi License, Example When 10gigUpgrade License is Installed

Chapter 2 Licensing

Port or Interface Behavior

Received 0 broadcasts (0 multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 unknown protocol drops

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

Example: When 10gigUpgrade License is Installed

The following example shows how to install the 10gigUpgrade license:

Router# license install flash:10G-ac.lic

Installing licenses from "flash:10G-ac.lic"

Installing...Feature:10gigUpgrade...Successful:Supported

1/1 licenses were successfully installed 0/1 licenses were existing licenses

0/1 licenses were failed to install

Following is a sample output from the show license command:

Router#	show license
Index 1	Feature: AdvancedMetroIPAccess
	Period left: Life time
	License Type: Permanent
	License State: Active, In Use
	License Count: Non-Counted
	License Priority: Medium
Index 2	Feature: IPBase
Index 3	Feature: Gige4portflexi
Index 4	Feature: 10gigUpgrade
	Period left: Life time
	License Type: Permanent
	License State: Active, In Use
	License Count: Non-Counted
	License Priority: Medium

Flexi License

When a flexi license is not present, ports 4 to 7 are enabled. Ports 0 to 3, and ports 8 to 11 are disabled. This is the expected behavior. Interfaces that are disabled are in the administrative down state.

FLS-A901-4 flexi license is a combination of copper and SFP ports. This license is not tied to any port types. If you purchase a single FL-A901-4 license and install it, four ports are enabled and if you have two licenses, all the eight ports are enabled. You can purchase and install two flexi licenses in a router.

Note Flexi license is supported only on the Cisco ASR 901 10G router.

Example: When Flexi License is not Installed

The following error message appears when the flexi license is not installed and you use the show ip interface command on the interface:

Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide

2-8 OL-23826-09