Cisco Systems A9014CFD manual 39-32, Router# show mpls l2transport vc 3001 detail

Chapter 39 Remote Loop-Free Alternate - Fast Reroute

How to Configure Remote Loop-Free Alternate - Fast Reroute

Verifying Remote LFA-FRR Configuration for EoMPLS on an EVC Interface

To verify the remote LFA-FRR configuration for EoMPLS on an EVC interface, use the show commands described in the following examples.

Router# show mpls l2transport vc 3001 detail

Local interface: Gi0/0 up, line protocol up, Eth VLAN 200 up

Interworking type is Ethernet

Destination address: 3.3.3.3, VC ID: 1, VC status: up

Output interface: Vl4000, imposed label stack {18 16}

Preferred path: not configured

Default path: active

Next hop: 71.12.1.2

Create time: 00:13:47, last status change time: 00:04:20

Last label FSM state change time: 00:11:54

Signaling protocol: LDP, peer 3.3.3.3:0 up

Targeted Hello: 1.1.1.1(LDP Id) -> 3.3.3.3, LDP is UP

Graceful restart: not configured and not enabled

Non stop routing: not configured and not enabled

Status TLV support (local/remote)	: enabled/supported
LDP route watch	: enabled
Label/status state machine	: established, LruRru

Last local dataplane		status rcvd: No fault
Last BFD dataplane		status rcvd: Not sent
Last BFD peer	monitor	status rcvd: No fault
Last local AC	circuit status rcvd: No fault
Last local AC	circuit status sent: No fault
Last local PW	i/f circ status rcvd: No fault
Last local LDP TLV		status sent: No fault
Last remote LDP TLV		status rcvd: No fault
Last remote LDP ADJ		status rcvd: No fault
MPLS VC labels: local 16, remote 16

Group ID: local 0, remote 0

MTU: local 1500, remote 1500

Remote interface description:

MAC Withdraw: sent:1, received:0

Sequencing: receive disabled, send disabled

Control Word: On (configured: autosense)

Dataplane:

SSM segment/switch IDs: 1434251/4096 (used), PWID: 1

VC statistics:

transit packet		totals:	receive 0, send 260970
transit	byte totals:		receive	0,	send 24009240
transit	packet	drops:	receive	0,	seq error 0, send 0

Local interface: Gi0/0 up, line protocol up, Eth VLAN 200 up

Interworking type is Ethernet

Destination address: 4.4.4.4, VC ID: 1, VC status: standby

Output interface: Vl4000, imposed label stack {21 16}

Preferred path: not configured

Default path: active

Next hop: 71.12.1.2

Create time: 00:13:47, last status change time: 00:14:41

Last label FSM state change time: 00:12:47

Signaling protocol: LDP, peer 4.4.4.4:0 up

Targeted Hello: 1.1.1.1(LDP Id) -> 4.4.4.4, LDP is UP

Graceful restart: not configured and not enabled

Non stop routing: not configured and not enabled

	Status TLV support (local/remote)		: enabled/supported
	LDP route watch		: enabled
	Label/status state machine		: established, LrdRru
	Last local dataplane	status rcvd: No fault
	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
39-32			OL-23826-09