Cisco Systems A9014CFD manual Specifies the gigabit ethernet interface to configure, 13-5

Chapter 13 Configuring MST on EVC Bridge Domain

Contents

Figure 13-2 MST with untagged EVCs without loop

Complete the following steps to configure MST on EVC bridge domain.

	Command	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router# enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	interface gigabitethernet slot/port	Specifies the gigabit ethernet interface to configure.
		• slot/port—Specifies the location of the interface.
	Example:
	Router(config)# interface
	gigabitethernet 0/1

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		13-5