Cisco Systems A9014CFD manual Configuring ATM over Mpls Pseudowire Interface, 36-6

Chapter 36 Configuring Inverse Muliplexing over ATM

Configuring ATM IMA over MPLS

7.no atm ilmi-keepalive

DETAILED STEPS

	Command	Purpose
Step 1	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2	configure terminal	Enters the global configuration mode.
	Example:
	Router# configure terminal
Step 3	controller {t1 e1} slot/port	Selects a T1 or E1 controller and enters controller configuration
		mode.
	Example:
	Router(config)# controller E1 0/4
Step 4	interface ATMslot/IMAgroup-number	Specifies the slot location and port of IMA interface group.
		• slot—Specifies the slot location of the ATM IMA port adapter.
	Example:	• group-number—Specifies the group number of the IMA group.
	Router(config-controller)# interface
	ATM0/IMA0
Step 5	no ip address	Disables the IP address configuration for the physical layer
		interface.
	Example:
	Router(config-if)# no ip address
Step 6	atm bandwidth dynamic	Specifies the ATM bandwidth as dynamic.
	Example:
	Router(config-if)# atm bandwidth
	dynamic
Step 7	no atm ilmi-keepalive	Disables the ILMI keepalive parameters.
	Example:
	Router(config-if)# no atm
	ilmi-keepalive

Configuring ATM over MPLS Pseudowire Interface

You can configure ATM over MPLS in the following modes:

•Configuring a Port Mode Pseudowire, page 36-7

•Configuring an N-to-1 VCC Cell Mode, page 36-7

•Configuring an N-to-1 vPC Cell Mode, page 36-8

•ATM AAL5 SDU VCC Transport, page 36-9

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
36-6	OL-23826-09