Cisco Systems A9014CFD manual 21-5

Chapter 21 Configuring Pseudowire

Configuring Pseudowire

DETAILED STEPS

	Command			Purpose
Step 1
	enable			Enables privileged EXEC mode.
				• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal			Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	pseudowire-class class-name			Creates a new pseudowire class.
	Example:
	Router(config)# pseudowire-class
	newclass
Step 4
	encapsulation mpls			Sets an encapsulation type.
	Example:
	Router(config-pw-class)#
	encapsulation mpls
Step 5
	interface cemslot/port			Configures the pseudowire interface to use for the new pseudowire class.
				This example shows a CESoPSN interface.
	Example:
	Router(config)# interface cem0/0
Step 6
	cem group-number			Defines a CEM channel.
	Example:
	Router(config-if)# cem 0
Step 7
	xconnect ip pw-class			Binds an attachment circuit to the CESoPSN interface to create a
	pseudowire-class			CESoPSN pseudowire. Use the pw-classparameter to specify the
				pseudowire class that the CESoPSN pseudowire interface uses.
	Example:
	Router(cfg-if-cem)# xconnect
	1.1.1.1 40 pw-class myclass
		Note	You cannot use the encapsulation mpls parameter with the pw-classparameter.
		Note	The use of the xconnect command can vary depending on the type of pseudowire you configure.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		21-5