Cisco Systems A9014CFD manual Setting up MP-BGP Peering to the Neighboring PE, 37-10

Chapter 37 IPv6 over MPLS: 6PE and 6VPE

How to Configure IPv6 over MPLS: 6PE and 6VPE

	Command	Purpose
Step 4	address-family ipv6 [vrf vrf-name]	Enters address family configuration mode for configuring routing
		sessions, such as BGP, that use standard IPv6 address prefixes.
	Example:	• vrf—(Optional) Specifies all VRF instance tables or a specific
	Router(config-router)# address-family	VRF table for an IPv6 address.
	ipv6 labeled-unicast	• vrf-name—(Optional) A specific VRF table for an IPv6
		address.
Step 5	neighbor {ip-address ipv6-address	Adds an entry to the BGP or multiprotocol BGP neighbor table.
	peer-group-name}remote-asas-number	• ip-address—IP address of a peer router with which routing
	Example:	information will be exchanged.
		• ipv6-address—IPv6 address of a peer router with which routing
	Router(config-router-af)# neighbor
		information will be exchanged.
	10.108.1.2 remote-as 65200
		• peer-group-name—Name of the BGP peer group.
		• remote-as—Specifies a remote autonomous system.
		• as-number—Number of an autonomous system to which the
		neighbor belongs, ranging from 1 to 65535.
Step 6	neighbor {ip-address ipv6-address	Enables the exchange of information with a BGP neighbor.
	peer-group-name}activate
	Example:
	Router(config-router-af)# neighbor
	10.0.0.44 activate
Step 7	exit-address-family	Exits BGP address-family submode.
	Example:
	Router(config-router-af)#
	exit-address-family

Setting up MP-BGP Peering to the Neighboring PE

To configure MP-BGP peering to the neighboring PE routers, complete the following steps:

SUMMARY STEPS

1.enable

2.configure terminal

3.router bgp as-number

4.address-family vpnv6

5.neighbor {ip-address ipv6-address peer-group-name}activate

6.neighbor {ip-address ipv6-address peer-group-name}send-communityextended

7.exit-address-family

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
37-10	OL-23826-09