Cisco Systems A9014CFD manual Configuring LFA-FRR for ATM/IMA, 39-21

Chapter 39 Remote Loop-Free Alternate - Fast Reroute

How to Configure Remote Loop-Free Alternate - Fast Reroute

	Command	Purpose
Step 9	xconnect peer-ip-address vc-id	Binds an attachment circuit to a pseudowire, and to configure an
	encapsulation mpls	Any Transport over MPLS (AToM) static pseudowire.
	Example:	• peer-ip-address—IP address of the remote provider edge (PE)
		peer. The remote router ID can be any IP address, as long as it
	Router(config-if-srv)# xconnect	is reachable.
	10.0.0.4 4 encapsulation mpls	• vc-id—The 32-bit identifier of the virtual circuit (VC) between
		the PE routers.
		• encapsulation—Specifies the tunneling method to encapsulate
		the data in the pseudowire.
		• mpls—Specifies Multiprotocol Label Switching (MPLS) as the
		tunneling method.
Step 10	backup peer peer-ip-address vc-id	Specifies a redundant peer for a pseudowire VC.
		• peer-ip-address—IP address of the remote peer.
	Example:
	Router(config-if-ether-vc-xconn)#
	backup peer 10.0.0.5 4

Configuring LFA-FRR for ATM/IMA

To configure LFA-FRR for ATM/IMA, complete the following steps:

Note Effective with Cisco IOS release 15.4(1)S, the TDM Pseudowire Redundancy over FRR feature is supported.

SUMMARY STEPS

1.enable

2.configure terminal

3.controller {e1 t1} slot/port

4.ima-groupima-group-number

5.exit

6.interface ATM slot/IMA group-number

7.no ip address

8.no atm enable-ilmi-trap

9.pvc VPI/VCI l2transport

10.xconnect ip-addressencapsulation mpls

11.backup peer peer-ip-address vc-id

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		39-21