Cisco Systems A9014CFD manual Mac-address target-address -Specifies, 11-7

Chapter 11 ITU-T Y.1731 Performance Monitoring

How to Configure ITU-T Y.1731 Performance Monitoring

	Command	Purpose
Step 4
	ethernet y1731 delay DMM domain domain-name{evc	Configures two-way delay measurement and enters
	evc-id vlan vlan-id} {mpid target-mp-id	IP SLA Y.1731 delay configuration mode.
	mac-address target-address}cos cos {source {mpid	• DMM—Specifies that the frames sent are Delay
	source-mp-id mac-addresssource-address}}
		Measurement Message (DMM) synthetic frames.
	Example:	• domain domain-name—Specifies the name of
	Router(config-ip-sla)# ethernet y1731 delay DMM	the Ethernet maintenance Operations,
	domain xxx evc yyy mpid 101 cos 4 source mpid 100	Administration & Maintenance (OAM) domain.
		• evc evc-id—Specifies the EVC identification
		name.
		• vlan vlan-id—Specifies the VLAN identification
		number. The range is from 1 to 4096.
		• mpid target-mp-id—Specifies the maintenance
		endpoint identification numbers of the MEP at
		the destination. The range is from 1 to 8191.
		• mac-addresstarget-address—Specifies the
		MAC address of the MEP at the destination.
		• cos cos—Specifies, for this MEP, the class of
		service (CoS) that will be sent in the Ethernet
		message. The range is from 0 to 7.
		• source—Specifies the source MP ID or MAC
		address.
		• mpid source-mp-id—Specifies the maintenance
		endpoint identification numbers of the MEP
		being configured. The range is from 1 to 8191.
		• mac-addresssource-address—Specifies the
		MAC address of the MEP being configured.
Step 5
	aggregate interval seconds	(Optional) Configures the length of time during
		which the performance measurements are conducted
	Example:	and the results stored.
	Router(config-sla-y1731-delay)# aggregate interval	• seconds—Specifies the length of time in seconds.
	900	The range is from 1 to 65535. The default is 900.

	Cisco ASR 901 Series Aggregation Services Router Software Configuration Guide
OL-23826-09		11-7